Slide 1 -
Slide 1
Slide notes
This is a Report Layout in progress. Whether we are
busy with the 1st or any subsequent Layout Design session on the Report, we
create Tags only by inserting 2 pipe symbols next to each other, wherever we want
to have a Tag. The Tags that we see here have been inserted before, and was
subsequently numbered by DocWriter.
Slide 2 - Slide 2
Slide notes
Slide 3 - Slide 3
Slide notes
Slide 4 - Slide 4
Slide notes
Slide 5 - Slide 5
Slide notes
Slide 6 - Slide 6
Slide notes
It is allowed to delete a Tag from the Layout, and
it is the correct way to be rid of a Tag that is no longer wanted.
Slide 7 - Slide 7
Slide notes
Slide 8 - Slide 8
Slide notes
Slide 9 - Slide 9
Slide notes
Slide 10 - Slide 10
Slide notes
Slide 11 - Slide 11
Slide notes
We do not change Tags, and we do not number Tags.
We may insert pipes for new Tags, and we may delete Tag numbers from the
Layout. That is the correct procedure.
Slide 12 - Slide 12
Slide notes
Slide 13 - Slide 13
Slide notes
Slide 14 - Slide 14
Slide notes
Slide 15 - Slide 15
Slide notes
Slide 16 - Slide 16
Slide notes
Slide 17 - Slide 17
Slide notes
Slide 18 - Slide 18
Slide notes
After making any changes on the Layout, we use the
'Find New Tags' function to update the internal Tag list. This function will
recognize where Tags have been dropped, and it will find and number any new
Tags.
Slide 19 - Slide 19
Slide notes
Slide 20 - Slide 20
Slide notes
Slide 21 - Slide 21
Slide notes
Slide 22 - Slide 22
Slide notes
Slide 23 - Slide 23
Slide notes
Slide 24 - Slide 24
Slide notes
Slide 25 - Slide 25
Slide notes
Slide 26 - Slide 26
Slide notes
If we check our Layout again, then we can see that
the system has found the newly inserted Tags, and numbered them. Even when
these new Tag Numbers are higher than Tag numbers below, it does not matter,
and it all depends on numbers that are available when the new Tags are
numbered.In this case, there were lower Tag numbers available, but the Tag
numbers do not determine the order in which Tags are calculated. Instead, Tags
are calculated from left to right and top to bottom, and based on Calculation
Iteration number.
Slide 27 - Slide 27
Slide notes
Slide 28 - Slide 28
Slide notes
Slide 29 - Slide 29
Slide notes
Slide 30 - Slide 30
Slide notes
When we look at the internal Tag list, we can also
see the new Tags that have been numbered.
Slide 31 - Slide 31
Slide notes
Slide 32 - Slide 32
Slide notes
Slide 33 - Slide 33
Slide notes
We can also see the illegally inserted Tag 1234.
Although the Tag has been included, it will cause problems and will not work
correctly, because it was not numbered by the system. We should delete it from
the Layout, and then it will disappear here as well.